M&P Flange & Pipe Protection     Call Toll-Free 1-800-888-2605  Plastic Machining  Acetal Machined Parts  CPVC Machined Parts  Delrin Machined Parts  ETFE Machined Parts  ECTFE Machined Part  FEP Machined Part  Fluorosint Machined Parts  Halar Machined Part  Kel-F Machined Part  Macor Ceramic  Neoflon Machined Parts  Nylatron Machined Parts  Peek Machined Parts  Polyamide-Imide Parts  Polyimide Parts  Polyurethane Molded Part  PPS Machined Part  PTFE Machined Parts  PVC Machined Parts  Rulon Machined Part  Ryton PPS Parts  Semitron Parts  Techtron Machined Parts  Teflon Machined Parts  Tefzel Machined Parts  Torlon Parts  Turcite Parts  UHMW Machined Parts  Ultem Parts  Vespel Machined Parts  Home  E-Mail  Map  Terms FLUOROSINT® MACHINED PARTS M&P can make custom Fluorosint® Machined Parts to your specifications. MATERIAL DESCRIPTION Fluorosint® is a proprietary mixture in which synthetically manufactured mica is chemically linked to PolyTetraFluoroEthylene (PTFE). This bonding results in properties not normally attainable in reinforced PTFE. Fluorosint® grades offer an excellent combination of low frictional properties and dimensional stability. Fluorosint® is produced only by Quadrant DSM Engineering Plastic Products. Fluorosint® offers excellent chemical resistance and continuous use temperature of 500°F (260 °C). Compared with PTFE, it has higher load carrying capability, 1/9 of the deformation under load, and a lower coefficient of thermal expansion. GRADES OF FLUOROSINT Fluorosint® 500 Fluorosint® 500 has nine times greater resistance to deformation under load than unfilled PTFE. Its coefficient of linear thermal expansion (CLTE) approaches the expansion rate of aluminum and is 1/5 that of PTFE -- often eliminating fit and clearance problems. It is 1/3 harder than PTFE, has better wear characteristics, and maintains low frictional properties. Fluorosint® 500 is also non-abrasive to most mating materials. Fluorosint ® 207 Fluorosint® 207's unmatched dimensional stability, excellent creep resistance and white color uniquely position this material to serve FDA regulated applications. It is non-permeable in steam and complies with FDA regulation 21 CFR 175.300. It's relative wear rate is 1/20 the rate of PTFE below 300°F (150°C). CUSTOM MACHINED PARTS Processing and machining of Fluorosint® parts take place in a completely controlled environment. We maintain a complete record of our products. We build excellence into every part we machine.  M&P's state of the art facilities are always open for you to visit. For a quote on your custom Fluorosint parts click on the email link provided or give us a call at 1-800-888-2605. Some Fluorosint® parts we machine are: Balls Nozzels Semiconductor Parts Back Up Rings Pads Sheaves Blocks Parts Spacers Bushings Plugs Supports Cams Rings Valve Seats Caps Rods Washers Guides Rollers Wear Pads Medical Parts Seals          Fluorosint ® is the registered trademark of Quadrant DSM Engineering Plastic Product.   Machined Parts     Plastic Distribution     Flange Protection     Pipe Protection     Gaskets   Accessories       Terms     E-Mail     Map     Home    M&P Flange & Pipe Protection Inc.  9426 Old Katy Rd Bldg #11  Houston, TX 77055  Phone: 800-888-2605   Fax: 713-463-6343        mailto:sales@m-p.com  Copyright © 2008